Getting ready for a 2 week road trip from Colorado to California, then back through S Utah, I’m deciding it is finally time to outfit the Element with a proper bed. In looking under the trim piece where the rear seats attach, I noticed that a Honda-made unistrut piece exists! And, it is compatible with standard spring strut nuts. I am going to weld up a frame from 1″ square tubing, that will attach at these two points with wing nuts and all thread. There will be 2 vertical supports at the rear, and a piano hinge at the front, so that part of the platform will store folded over the back section, and will fold forward and be supported by the front seats. Puctures of that to come. My idea is to have full access under the platform for storage.
Leave a Reply